Note: Not all machines can take advantage of this feature. Setting a value of 0.0 for the plunge gap will also disable this feature. If you set the Plunge (Z2) gap to a smaller value than the Clearance (Z1) gap, the tool will plunge at rapid feed rate to the specified distance above the material surface before changing to the specified plunge rate.įor jobs where a large value for Clearance (Z1) gap has to be specified to avoid clamps etc, this feature can save a considerable amount of machining time if there are many plunge moves in the job. My machine rapids at speeds over 2000 but with with the rapid set to 2000 and the scale factor to 1 Vectric calculates a machine time of 1 hour and 53 minutes. This way you can make a estimated machine time, to decide the actual cost for your customer. The Plunge (Z2) is an added feature. As well as specifying a rapid clearance gap for rapid positioning moves above the work piece, the user can also specify a much smaller gap that the tool will rapid down to during plunge moves.īy default, the Plunge gap is set to the same value as the Clearance gap, which means that there will be no rapid plunges. Set the rapid rate to something you desire, in my case its set to 2000mm/min. Additionally, Vectric VCarve Desktop contains a comprehensive set of.
Vectric vcarve pro set rapid software#
The software will raise the bottom of the cutter to this height when it traverses the material. Photo & Graphics tools downloads - VCarve Pro by Vectric Limited and many more. This is the height above the job at which it is safe for the cutter to move at rapid or maximum feed rate.
Vectric vcarve pro set rapid full#
The Clearance (Z1) is the most important setting. VCarve Pro can import 2D designs from other programs but also provides a full set of drawing and editing tools. These are also referred to as the Safe Z settings.
tif) Import the image and use the image tracing / vectorization tools in VCarve Pro or Aspire to convert the bitmap design to the required vector outlines. When you open the Material Setup form using the Setup Material and Rapid Gaps tool in the Toolpath Tab, you will see settings for Clearance (Z1) and Plunge (Z2). Vectric Vcarve Pro 6. VCarve native format (.crv) DXF format (.dxf) Encapsulated Postscript (.eps) in vector format If the artwork is still in a bitmap format (such as.
0 kommentar(er)
